The Ronin is a camera stabilization system designed to give the operator close to the freedom of unencumbered handheld shooting but without the hand-shake. Suitable for most camera types and configurations up to 16 pounds, Ronin uses brushless motors that work on three axes: one for side-to-side «roll» — keeping the horizon level — one for tilt, and one for pan.
Dimensions (WxHxD) 620 x 280-380 x 500 mm
Weight 4,20 kg
Supported camera dimensions Maximum depth at center of mass on camera base plate: 140mm

Maximum height measured from top of camera base plate: 225mm

Maximum width: 195mm

Load capacity 7,25 kg
Operating temperature -15°C ~ 50°C
Built-in functions — Three Operation Modes:
Underslung Mode
Upright Mode
Briefcase Mode
— Built-in independent IMU module
— DJI Specialized Gimbal Drive Motors with Encoders
— Bluetooth Module
— USB Connection
— 2.4GHz Receiver
— Temperature Sensor
— DJI Advanced 32-Bit DSP Processor
— D-Bus Supported

Request information or quotation

Пожалуйста подождите

Найти больше:

Exact matches only
Search in title
Search in content
Search in excerpt
Search in comments
Filter by Custom Post Type

Смотрите еще:



Send this to a friend